#33 ERROR(ORCAP-36004): Conflicting values of part name found on different sections of "U1". Conflicting values: S3C6410X_6_S3C6400-424FBGA_S3C6410X & S3C6410X_3_S3C6400-424FBGA_S3C6410X Property values of "Device","PCB FootPrint", "Class" and "Value" should be identical on all sections of the part. #34 ERROR(ORCAP-36004): Conflicting values of part name found on different sections of "U1". Conflicting values: S3C6410X_6_S3C6400-424FBGA_S3C6410X & S3C6410X_2_S3C6400-424FBGA_S3C6410X Property values of "Device","PCB FootPrint", "Class" and "Value" should be identical on all sections of the part. #35 ERROR(ORCAP-36004): Conflicting values of part name found on different sections of "U1". Conflicting values: S3C6410X_6_S3C6400-424FBGA_S3C6410X & S3C6410X_4_S3C6400-424FBGA_S3C6410X Property values of "Device","PCB FootPrint", "Class" and "Value" should be identical on all sections of the part. #36 ERROR(ORCAP-36018): Aborting Netlisting... Please correct the above errors and retry. ======================================================================================= 解决方法: You've obviously edited one part of the symbol and assigned it the same ref des as the other part. You need to go back into the cache and replace all occurrences of the symbol with the corrected part. This happens when you copied the part from other schematics and edited the value only. But the content of "Device" and "Value" of parts should be same in schematics. Just change the content of Device as the Value of part. Or leave the Device as blank. |